Micropterus salmoides

Bass Fishing Forum Bass Fishing Forum

Site Slogan

News: Forum updated, problems HERE if you see any!

Rod Holder for boaters

(Read 1672 times)

0 Members and 1 Guest are viewing this topic.


BECOME A CHARTER MEMBER SUPPORT UB

Kal-Kevin

  • Bass Fishing Junkie
  • Ultimate Basser
  • *****
  • *
  • Posts: 18,128
  • Location: Kalamazoo, Michigan
  • Gender: Male
  • Member of Kal-Valley Bass Club
If you need to have a spot to hold your fishing pole while you reset a bait or just do something for a minute. Take a piece of pvs pipe about 12 inches long and a off set Y connection, the Y should be where two of the wholes are straight across from each other the third is at 45 degrees of one of the other ones. Lift your seat part of your seat off up on the deck, place the Y over the pole then add 6 to 8 inches of the pipe in the top of the connection. The third whole should point up at a 45 and place the remaining piece of pipe there, replace the seat. Now you have a place to hold your pole while your fishing. One last note pipe size will depend on the size of pole your have and what will slid over it. you can make the third whole smaller if you wish for less movement of the pole.

Good Fishing!
Kal

Last Edit: June 03, 2006, 06:20:22 AM by Kal-Kevin


 


BECOME A CHARTER MEMBER SUPPORT UB